Resource Data Management PR0018-PHI Guia do Utilizador descarregar pdf (Página 16)

Revision 1.0 Page 16 of 29

Warning

Please Note

The specifications of the product detailed on this

Set-Up Guide may change without notice. RDM

Ltd. shall not be liable for errors or for incidental

or consequential damages, directly and indirectly,

in connection with the furnishing, performance or

misuse of this product or document.

Ensure that all power is

switched off before

installing or maintaining

this product

Mercury 3 M & E Installation Guide

www.resourcedm.com

stay off.

Electric CIn – Defrost heater will go off during defrost min. period if defrost termination is achieved but will

then cycle on and off around the termination temperature setpoint until the end of the defrost min. period.

Gas (Mobile) - If gas is selected, the compressor is kept running for the duration of the defrost cycle.

P-80

Door alarm delay

Delay after the door open input is activated before the alarm occurs.

P-81

Door Closes Valve

This parameter is used to close the LLV or EEV if the door opens. If the door remains open then the valve

will resume normal operation on the expiry of the door alarm delay (P-80).

P-82

Door Stops Fan

This parameter is used to stop the fans if the door opens. If the door remains open then the fans will

resume normal operation on the expiry of the door alarm delay (P-80).

P-60

Lights Mode

Allows the user to set the lights mode: -

 Always off

 Always on

 Use a local schedule P-61 to P-74)

 Use a remote schedule (Set up in the system front end)

P-61

Sun Lights On

When P-60 is set to Local, Sunday on time

P-62

Sun Lights Off

When P-60 is set to Local, Sunday off time

P-63

Mon Lights On

When P-60 is set to Local, Monday on time

P-64

Mon Lights Off

When P-60 is set to Local, Monday off time

P-65

Tue Lights On

When P-60 is set to Local, Tuesday on time

P-66

Tue Lights Off

When P-60 is set to Local, Tuesday off time

P-67

Wed Lights On

When P-60 is set to Local, Wednesday on time

P-68

Wed Lights Off

When P-60 is set to Local, Wednesday off time

P-69

Thu Lights On

When P-60 is set to Local, Thursday on time

P-70

Thu Lights Off

When P-60 is set to Local, Thursday off time

P-71

Fri Lights On

When P-60 is set to Local, Friday on time

P-72

Fri Lights Off

When P-60 is set to Local, Friday off time

P-73

Sat Lights On

When P-60 is set to Local, Saturday on time

P-74

Sat Lights Off

When P-60 is set to Local, Saturday off time

P-30

Broadcast ID

ID of Plant Controller being used to broadcast Suction Pressure

The Broadcast ID is derived from the Rotary Switch positions set on the Plant controller which is providing

the remote suction pressure.

Note: No two Plant controllers on a local area network can have the same rotary switches positions set.

This will have adverse effects on control.

P-31

Refrigerant

Type of refrigerant used in system. See: Refrigerant Table above

P-32

Pressure Units

Absolute or Gauge

P-33

Evap Offset

Offset to allow for pressure drop over distance

P-34

Glide

Allows the calculated temperature, derived from the Suction Pressure, to be offset by adding the value at

P-34.

P-35

Trans Span

Total range of the transducer

P-36

Trans Offset

Value below zero

dFLt

Restore default values

Restores all of the parameters to their default values

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 28 29

Comentários a estes Manuais

Sem comentários

Resource Data Management PR0018-PHI Guia do Utilizador Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Comutadores de rede Resource Data Management PR0018-PHI